ここから本文です
TWO:Dangerous trying to land there! was the note Jeff passed back as Larry flew the airplane at just above stalling speed toward the shore. Dick agreed. After all, there might be automobiles in the parking lines, and the light might be bad for Larry. Even using a power-stall by which, with the engine going and a flat gliding angle, the airplane could settle gradually closer until it took the ground with hardly a jar, the maneuver would not be safe, Dick admitted.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:Presently the nurse came, a big, fat Mexican woman, with all her people's love of children showing on her moon face as she put out her arms. She had been with the Taylors since before the baby's birth, and she had more of its affection than the mother.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:Equally, his quick mind arrived at a good guess at the trouble.Jeff got his engine going by setting it on a compression point when he had primed the cylinders and using his booster magneto to furnish the hot sparks that gave it its first impulse.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:In his impatience to reach his beloved Hanover, the king had out-travelled his Minister and the mistress, and reached Delden on the 8th late at night. The next morning he proceeded again so early as four o'clock, and was pressing onward, when in the forenoon he was seized with a fit of apoplexy in his coach, and on arriving at Ippenburen he was observed to be quite comatosehis eyes fixed, his hands motionless, and his tongue hanging from his mouth. His attendants wished to remain at Ippenburen to procure medical assistance; but this seemed to rouse him, and he managed to articulate, "Osnabrück! Osnabrück!" The only chance for his life, if there was any, depended on instant surgical aid; they went in obedience to his command, and on arriving at Osnabrück he was found quite dead on the 9th of June, 1727.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:"I reckon you'll know what for, then," beamed Taylor, immovably.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.